Retro-DWS Installation
7 of 12
Electrical Installation and Testing
TEST
RESET
Pilot light
(120V 15A example shown)
A. Unpack the Retro-DWS system plug from its protective package.
B. Plug into your dedicated outlet. 120V outlet (5-15R) for 120V sys-
tems or 240V outlet (6-15R) for 240V systems.
C. Push RESET button on the cord set ground fault device until light
turns ON. If light does not illuminate check power to outlet. Do
not remove or tamper with the cord set. If used with a thermostat
it may be necessary to bypass the thermostat control and plug
directly into receptacle to perform test.
D. Push TEST button and light will turn OFF. This indicates that the
electrical circuit is intact and fully protected.
E. Push RESET button again and light will turn ON. This indicates that
your Retro-DWS is working.
F. Follow this test procedure before each season and monthly while in use.
Your Retro-DWS is now fully functional.
If at any time your Retro-DWS system fails to work call your local electri-
cian or Heat-Line for assistance at (800) 584-4944.
Electrical System Check on GFC Models
(perform monthly while in use)
NOTE:
GFCI model shown may not
represent actual GFCI.
During the time periods and subject to the conditions hereinafter set
forth. Heat-Line will repair or replace to the original user any portion
of your Retro-DWS product which proves defective in materials or
workmanship of Heat-Line. Contact Heat-Line or your installer for
warranty service.
At all times Heat-Line shall have and possess the sole right and option
to determine whether to repair or replace defective equipment, parts
or components.
Damage due to natural events or conditions beyond
the control of Heat-Line are NOT COVERED BY THIS WARRANTY.
STANDARD WARRANTY PERIOD:
60 months from date of purchase or
63 months from date of manufacture, which ever occurs first.
EXTENDED WARRANTY PERIOD:
120 months from date of purchase or
123 months from date of manufacture, which ever occurs first.
ACCESSORIES, COMPONENTS, ELECTRONICS:
Not manufactured by
Heat-Line, are warranted only to the extent of original manufacturer’s
warranty.
LABOUR, COSTS, ETC.:
Heat-Line shall in NO EVENT be responsible
or liable for the cost of field labour or other charges
incurred by any
customer in removing and/or reaffixing any Heat-Line product, part or
component thereof.
THIS WARRANTY WILL NOT APPLY:
(a) to defects or malfunctions resulting from failure to properly install,
operate or maintain the unit in accordance with printed instructions
provided,
(b) to failures resulting from abuse, accident or negligence;
(c) to normal maintenance services and
(d) to parts not used in accordance with applicable local codes, ordi-
nance and good trade practices;
(e) if the unit is moved from its original installation location or
(f) if the unit is used for purposes other than for what it was
designed and manufactured,
(g) to the integral ground fault device and related electronics.
PRODUCT IMPROVEMENTS:
Heat-Line reserves the right to change
or improve its products or any component thereof without being obli-
gated to provide such a change or improvement for units sold and/or
shipped prior to such change or improvement.
WARRANTY EXCLUSIONS:
As to any Heat-Line product after the expi-
ration of the time period of the warranty applicable thereto as set forth
above. There will be no warranties including any implied warranties of
merchantability or fitness for any particular purpose. No warranties or
representations at any time made by any representative of Heat-Line,
shall vary or expand the provisions hereof.
LIABILITY LIMITATION:
In no event shall Heat-Line be liable or respon-
sible for consequential, incidental or special damages resulting from
or related in any manner to any Heat-Line product or parts thereof. In
the absence of suitable proof of the purchase date, the effective date of
this warranty will be based upon the date of manufacture plus 90 days.
Limited Warranty
