Heat Controller VMH 30 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 4 / 12

3
Heat Controller, Inc.
VMH 30/36 SERIES
Installation, Operation & Maintenance
There should not be any heat source near the unit.
There should not be any obstacles blocking the
air circulation.
A place where air circulation in the room is good.
A place where drainage can be easily done.
A place where noise prevention is taken into
consideration.
Do not install the unit near a door way.
Ensure the clearness indicated by arrows
in the figure on the right are adhered to
leaving space away from any walls, ceiling,
or other obstacles.
There should not be any direct sunlight.
If unavoidable, sunlight prevention should be
taken into consideration. Direct sunlight may
block the ability of the unit to reduce the signal
from the remote controller.
SELECT THE BEST LOCATION
Indoor unit
Outdoor unit
If an awning is built over the unit to prevent
direct sunlight or rain, be careful that heat
radiating from the condenser is not obstructed.
There should not be any animals or plants kept
near the unit which could be affected by hot air
discharged.
Ensure the clearances indicated by the arrows on
the right are adhered to, leaving space away from
any walls, fences, plants, or other obstacles.
See outdoor installation precautions on
page 7 for additional information.
NOTE:
1
2
3
4
5
6
7
8
Installation Plate
Clip Anchor
Self-tapping Screw A ST3.9x25
Seal
Drain Joint
Remote controller
Self-tapping Screw B ST2.9x10 1
5-8(
) depending on models
5-8( ) depending on models
1
1
1
2
1
In addition to the parts above, other parts may need to be purchased locally.
such as copper line sets, etc.
Remote controller holder
ACCESSORIES
Number Name of Accessories
Qty
NOTE
:
optional
parts
6 inches
8 feet
6 inches
5 inches
2 feet
1 foot
2 feet
1 foot
7 feet
P-Trap