Heat & Glo • Escape-I35FB, Escape-I30FB • 2201-900 Rev. K • 5/11
30
A. Remove Glass Assembly
See Section 12.I.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Inspect Firebox
Surface cracking or crazing of fi rebrick material is normal
and expected. The following types of cracks are acceptable
and do not require replacement of the unit or the fi rebox:
• Cracks that do not propagate entirely through the
material.
• Light fracture lines or “spider-webbing” on the surface of
the material.
• Cracks that are less than 1/32 in. wide and less than 3
in. long.
• If cosmetically unacceptable, such cracks may be
repaired with the SRV-PACK service kit. See Service
Parts List.
Cracks that are unacceptable:
• Cracks greater than 1/32 in. wide and 3 in. long are at
risk of growing.
• Cracks that penetrate entirely through the firebrick
material.
Inspection for cracking should be run when the appliance
is cool. Cracks tend to close as the appliance heats up.
D. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
E. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock!
Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
F. Place the Lava Rock
WARNING! Risk of Explosion!
Follow lava rock place-
ment instructions in manual.
DO NOT place lava rock on
burner. Improperly placed lava rock interferes with proper
burner operation.
Lava rock is shipped with this gas appliance. To place the
lava rock:
• Lava rock CANNOT be placed on the burner.
• Place lava rock in front of and to the sides of the burner.
12
Appliance Setup
PLACE LAVA ROCK IN GRAY AREA ONLY
Figure 12.1 Placement of Lava Rock
