28
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. Q • 6/10
C. Fan Operation
The accessory fan is wired in series with a speed con-
trol switch and a temperature sensor switch. Set the
speed control to an "ON" position and light the heater.
The temperature sensor switch will automatically start
the fan when the switch warms up—and stop the fan
when it cools down. You can manually stop the fan by
turning the speed control switch to "OFF". See Figure
1.30 for fan wiring diagram.
SWITCH IS SHOWN
IN “ON” POSITION
Figure 2.2
B. Power Outage
In the event of a power interruption during operation,
either push the OFF button on the remote control or
open access door and push the switch to OFF (as
shown in Figure 39) to shut off manually. The switch
must be returned to the ON position prior to operation
once power is restored.
