Heat & Glo LifeStyle Collection • Twilight-II • 2087-900 Rev. G • 12/05
24
STEP 8.
LOG #7 (SRV703-703): Place log #7 on
the grate tine between log #2 and log #5. Rest one
end on the burner making sure not to cover any port
holes.
STEP 7.
LOG #6 (SRV2077-701): Set log #6 onto the grate bar as shown. Lay the “Y” end of log #6 onto log
#1 resting it into the small depression of log #1.
F. Glass Assembly
Removing Glass Assembly
Remove wing nuts and glass clips around glass door. Re-
move glass door from the appliance.
Replacing Glass Assembly
Replace the glass door on the appliance.
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
WARNING
• Do NOT strike, slam or scratch glass.
• Do NOT clean glass with a razor blade.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete
appliance.
G. Grilles and Trim
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that
the bottom grille can be lowered and the trim door removed.
H. Shutter Settings
___________________________________________
NG
LP
Twilight-II
3/8”
Full Open
1
2
4
5
6
3
1
2
4
5
6
3
7
