HearthStone Quality Home Heating Products Inc
Stowe Model #8321
02044-1
9
Safety Standard, Title 24 CFR, Part 3280
(U.S.) or Standard for Manufactured Home
Installation, ANSI/NCBCS A225.1 or
Standard for Gas Equipped Recreational
Vehicles and mobile Housing, CSA
Z240.4.CAN/SCA Z240 MH (Canada).
(Installer l’appareil selon les codes ou
règlements locaux, ou, en l’absence de tels
règlements, selon les Codes d’installation
CAN/CGA-B149.)
For installations from 610-1370 meters
(2000-4500 ft.) the orifice sizes (DMS) for
natural and propane gas are 41 and 54
respectively. See data plate for additional
information. For high altitude installations
consult the local gas distributor or the
authority having jurisdiction for proper
rating methods. If the installer must convert
the unit to adjust for varying altitudes, the
information sticker must be filled out by the
installer, and adhered to the appliance at the
same time of conversion.
(Cet appareil est
equipè pour des altitudes compries entre 0
et 2000 pieds (0-610 m) seulement.)
I
TEMS
R
EQUIRED FOR
I
NSTALLATION
* External regulator (for propane/L.P.G. only)
* Piping which complies with local codes
* Pipe sealant approved for use with
propane/L.P.G. (resistant to sulfur compounds)
* Manual shutoff valve
* Sediment trap (see page 24)
* Tee joint
* Pipe wrench
* Phillips head screwdriver
* 7/16-inch wrench
* Other parts as required by local code
*Safety Glasses
*Gloves
P
ACKING
L
IST
1-Stowe Gas-Fired Heater
4-Decorative Ceramic Logs
1-Bag Charcoal Embers Only
1-Bag Charcoal Embers and “Rock Wool”
1-Owner’s Manual
1-Thermostat
1-40’ Thermostat wire
1-L.P. Fuel Conversion Kit
1-Warranty Validation Form
1-Exhaust Restrictor Plate with Mounting Screw
Note: Vent kits and components are supplied
separately. Failure to use the venting
components suggested by HearthStone will
void your warranty.
U
NPACKING AND
I
NSPECTION
Unpack and Inspect for Damage
The Stowe is packaged by HearthStone to
withstand normal shipment without damage.
However, damage can still occur during
transit; so take care to inspect for damage
when unpacking and installing the unit. If
any damage, or missing parts are detected,
immediately contact your dealer
.
Do not install, or put into service, a
damaged or incomplete heater.
Caution: The top grill is NOT cemented,
or otherwise permanently fastened in
place!
We recommend your Stowe be
moved into place, venting attached, gas and
electrical connections made, and any
accessory blower installed before installing
the top grille.
Inspect the Stowe for visible or concealed
damage. The unit should appear to be square
and true. The sheet metal parts should be
smooth and free of bends and dents. The
enameled cast iron should be free of chips or
cracks. If visible or concealed damage is
found, or suspected, contact your dealer for
instructions.
With the accessory box removed and set
aside, undo the lag bolts that fasten the unit
to the pallet. Take care not to mar or chip
the enameled legs. Have someone help lift
the stove off the pallet and set it into place.
