2
3
Vent-Free Gas Log Heater User Manual
Operation—(cont.)
1.
STOP!
Read all the above safety information before proceeding.
2.
to the “OFF” position
Turn the control knob clockwise
(see Fig.
20
.
3. Wait five (5) minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow “B” in
the safety information above. If you don’t smell gas, go to the
next step.
4. Turn the control knob counterclockwise
to the “PILOT”
position. Depress control knob.
5. With control knob depressed, push down on the ignitor button
until the pilot lights. The pilot is located behind the
heater screen near the rear of the burner (see Fig. 2
1
).
• Do not attempt to light the pilot by hand.
6. Keep the control knob depressed for (30) seconds after the
pilot lights. Then release the control knob.
• If the control knob does not pop up when released, stop and
immediately call a qualified service technician or gas supplier.
• If the pilot goes out, repeat steps 3 through 7. Wait (1) minute
before attempting to light pilot again. If after several tries the pi-
lot still goes out, turn the gas control knob clockwise
7. Turn the
HI / LOW
control knob
to the desired setting.
Fig. 20—Control Knob
Fig. 21—Pilot
TO TURN OFF GAS TO THE HEATER
1. Turn the control knob clockwise to the “OFF” position.
Shutting Off the Burner only (Pilot Stays Lit):
1. Turn the control knob clockwise to the “PILOT” position.
The fireplace screen must be in place while the heater is in operation.
Any glass doors must be completely opened while the heater is operating.
WARNING
WARNING
to the “OFF” position and call a qualified service technician.
LIGHTING INSTRUCTIONS
