Hearthland Hiawatha, Инструкция по установке и эксплуатации

Страница: 10 / 49

VS0952_E 12/30/2009 10
E
XHAUST
S
YSTEM
PELLET VENT TYPE:
⇒
Must be an approved 3” or 4” Diameter Type ”PL” vent, vented to the outside or connect the vent to a
factory built type “A” chimney using an adaptor.
⇒
Exception: A single wall “All Fuel” Stainless Steel chimney liner may be used inside a fireplace or fire ‐
place installations.
⇒
Some venting manufactures do make “PL” vent for use with wood pellet fuel only and another type of
“PL” vent for corn or bio mass fuels. If in doubt, plan for the future and use the corn or multi ‐ fuel.
⇒
Use 4” diameter vent if vent or liner height is over 15’ or if installation is over 3.000’ above sea level.
NOTE: 4” diameter vent may be used in all installations. If in doubt, use 4” diameter vent. (See diagram
on Page 11. )
VENT SAFETY PRECAUTIONS:
A “Clean Out Tee” ( A ) must be installed at the bottom of all vertical runs. These “Tee’s” are to assist in
periodically cleaning the vent. Single or Double clean out tees may be used. The exhaust system must
be installed so the entire system can be cleaned without disassembly.
Termination must exhaust above the fresh air inlet
elevation, and parallel or above the exhaust output
of the pellet fuel appliance.
It is highly recommended that at least 3 feet of vertical
pipe ( B ) be installed to create some natural draft. This
is to help prevent the possibility of smoke or odor dur ‐
Ing the appliance shut down.
Horizontal sections must have a 1/4” rise every 12” of
travel after 3’ long.
Use (3) fastening screws per joint.
Pellet vent connections must be sealed gas tight. Use
High Temp (550°F) RTV Silicone or Hi ‐ temp Aluminum foil
tape.
Seal each vent section by injecting a liberal amount of
sealant into the gap or wrap with foil tape.
It is strongly recommended that the exhaust system
be terminated on the prevailing wind side of the home.
Appliance may not be placed in, or vented through
•
THE PELLET VENT MUST MAINTAIN A MINIMUM 3” CLEARANCE TO ANY COMBUSTIBLE.
•
(INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER).
•
DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT.
•
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.
IMPORTANT