October 13, 2015
7034-276E
15
MT. VERNON AE
b. Manual
In MANUAL cycle, the heat output remains the same
regardless of the difference between the set and room
temperatures. The wall control will function as a simple
on/off thermostat. When the system is set to MANUAL
the HEAT OUTPUT selection is added in the lower right
corner.
Press the button under this selection to access this fea-
ture. The HEAT OUTPUT screen is used to set the level
of heat produced whenever the wall control calls for heat.
Figure 15.3.
The HEAT OUTPUT screen is not accessible
in AUTOMATIC cycle.
AUTO/MANUAL SETTINGS
Manual
Off
Automatic
Manual
Medium
AUTO/MANUAL SETTINGS
Automatic
Manual
Off
Figure 15.1
Figure 15.2
Figure 15.3
3. Fuel Type
The FUEL TYPE screen is used to select the fuel that will be
used with the pellet system. The list on this screen indicates
all fuel choices available to burn in the appliance.
NOTE: The list of fuels can be updated by your local
dealer as they become available.
Figure 15.5
c. OFF
This selection turns the appliance off. When the appli-
ance is set to OFF, it will not light regardless of room tem-
perature. Use this setting when cleaning and maintaining
your appliance.
Manual
Off
Automatic
Figure 15.4
To select a fuel type, use the UP/DOWN buttons to scroll to
the desired fuel type and then press the button under “Se-
lect”. The arrow will change to indicate the currently select-
ed fuel.
NOTE
: If you are burning a high ash fuel set the fuel selec-
tion to “Utility Pellets”.
When purchasing corn or wheat to burn in your appliance,
read the ingredient label very carefully.
Do NOT purchase
fuel that contains any additives
such as oils (i.e. soybean
oil) and meals as it will result in poor appliance performance.
If you are buying corn or wheat the only ingredient that should
be listed is corn or wheat.
4. Program (7 Day Programming)
The wall control is pre-programmed at 68
o
F for all time set-
tings. It will remain there until it is re-programmed.
The wall control can be programmed as a setback thermo-
stat. Each day of the week has four program periods. The
wall control menus have some features that make it easy to
Monday
Full Week
Mon-Fri
Sat-Sun
PROGRAMMING RANGE
Figure 15.6
Sunflower Seeds
Corn
Utility Pellet
Softwood Pellet
Wheat
Hardwood Pellet
DONE
SELECT
FUEL SELECTION
a. Full Week
NOTE:
It is important to note that the most recent program-
ming entry will override all previous programming for an indi-
vidual day or range of days.
The small triangle on the left side indicates the current active
programming line.
Figure 15.6.
For each of the four inter-
vals available to program there are three adjustable values:
set hour, set minutes and set temperature. You will need to
increase or decrease the hour to change from AM to PM.
program groups of days alike. This minimizes the number
of steps required to program the wall control for most appli-
cations.
To access the programming screen, select Program from
the menu screen and then select the desired programming
range from the PROGRAMMING RANGE screen.
