3
Hearth & Home Technologies • SMART-STAT Remote Control Instructions • 100-906 Rev. J • 2/17
Figure 3. Wiring Intermittent Pilot Ignition Dry Contact Ignition
The remote receiver has a 3-position slide switch: OFF/
REMOTE/ON (see Figure 4).
Figure 4. Remote Receiver
NOTE:
The slide switch should be placed in the OFF posi-
tion if you will be away from your home for an extended
period of time. Placing the switch in the OFF position also
functions as a safety “lock out” by turning the system off
and rendering the remote receiver inoperative.
TRANSMITTER
Important: Before operating remote control, transmitter
and receiver must have matching security codes. See
section ‘Matching Security Codes’.
Important:
Review ‘Communication-Safety Features’ un-
der ‘Transmitter Safety Features’ section. The communica-
tion safety features shut down the
fi
replace system when
a potentially unsafe condition exists.
Important:
Review ‘Auto Shutdown’ section. This safety
feature shuts down the
fi
replace after 9 hours of continuous
operation, in ON mode only.
Important:
New or fully charged batteries are essential
for proper operation of the multi-function transmitter. The
transmitter operates on 2 AAA-size 1.5V batteries. Use
Alkaline batteries for longer battery life and maximum
operational performance.
Insert 2 AAA-size 1.5V batteries into the battery compart-
ment on the back of the transmitter. When the batteries
are correctly inserted, the screen will display numbers (see
Figure 5 for LCD Display Screen).
NOTE:
If the transmitter is activated from a very cold
condition it may be necessary to allow the transmitter to
stabilize to room temperature (could take up to 15 minutes)
before accurate room temperatures are displayed on the
screen.
NOTE:
LCD screen is equipped with a “backlite” for easier
viewing of LCD screen. Backlite illuminates when a function
button is depressed. After 5 seconds elapses, LCD screen
will return to its normal state.
Slide
Switch
OFF
REMOTE
ON
LEARN
VALVE
ANTENNA
REMOTE RECEIVER
Dry Contact
(2) 1/4” female
Connectors
To 110VAC
input
I
S
Electronic
Module
Piggyback
Connectors
Switch
Wires
ON
REMOTE
OFF
R
A
E
L
N
Brown
NOTE: The remote receiver will only respond to the
transmitter when the 3-position slide button on the
remote receiver is in the Remote position. If the system
does not respond to the transmitter on initial use, see
section Matching Security Codes.
1. With the slide switch in the ON position, the system is on.
2. With the slide switch in the REMOTE position, the system
only operates if the remote receiver receives commands
from the transmitter.
3. With the slide switch in the OFF position, the system is off.
