7
4050-308 Rev A 9/13/2007
WARNING
Disconnect power at circuit breaker before attempting any
maintenance or cleaning to reduce the risk of fire, electrical
shock or personal injury.
REPLACING THE LIGHT BULB
This appliance uses a single 12 Volt, 35 Watt, MR-16 bulb.
The bulb is located behind the smoke shield.
A spare is provided with the unit. Replacement bulbs (Part
No. 4050-123) are available through your Simplifyre dealer.
•
Turn off power to the unit at the main service panel.
•
Let the fireplace cool if it has been operating.
•
Release the spring pins and remove the upper shield.
•
Remove the two screws on the projector basket.
•
Rotate the housing down to access the bulb.
•
Remove the screws holding the bulb and socket.
•
Unplug the bulb from the socket.
•
Replace the bulb.
•
Re-assemble in the reverse order.
SCREEN CLEANING
During shipment, installation, handling, etc., the
screen surface may collect dust particles; these can
be removed by lightly wiping with a clean, dry cloth.
MAINTENANCE OF MOTORS
The motors used on the fan and flame projector assembly
are pre-lubricated for extended bearing life and require no
further lubrication. However, periodic cleaning/vacuuming of
the fan/heater unit is recommended.
SERVICE INSTRUCTIONS
ELECTRICAL WIRING
1
5
Resetting the Temperature Cutout Switch
The heater on this fireplace is protected with a safety device
to prevent overheating. Should the heater overheat, an
automatic cutout will turn OFF the heater/blower. The switch
is reset by turning the unit OFF, waiting 10-15 minutes and
switching the unit back ON.
Содержание Simplifyre SFE-26
Страница 9: ...9 4050 308 Rev A 9 13 2007...
