18
TROUBLE SHOOTING
Problem
Cause
Correction
Monitor does not display
Batteries not installed
Insert batteries
No speed or distance
displays on the monitor
Connected wire doesn’t
connect with extension wire
of computer or sensor wire
Securely plug connected
wire into extension wire of
computer and sensor wire
Connected wire or sensor
wire damaged
Replace connected wire or
sensor wire
Computer
not
working
properly
Replace computer
No tension
Belt drops off the belt pulley
and groove of wheel
Put the belt back to the belt
pulley and groove of wheel
Grinding
Idler pulley defective
Replace idler pulley
Fan wheel defective
Replace fan wheel
Squealing
Poly V-belt slipping
Adjust poly v-belt
Crank bearing defective
Replace crank bearing
Idle wheel bearing defective
Replace idle wheel bearing
Fan wheel bearing defective
Replace fan wheel bearing
MAINTENANCE:
The safety and integrity designed into the Fan bike can only be maintained when the Fan bike is
regularly examined for damage and wear. Special attention should be given to the following:
1. Pedal slowly to verify that the Air Resistance System provides tension. The Air Resistance
System should provide many years of use.
2. Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember
that the left pedal has left hand threads and is tightened by turning counterclockwise.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten all loose nuts and bolts.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the Fan bike removed from
service until a repair is made.
6. Keep your Fan bike clean by wiping it off with an absorbent cloth after use.
