Healthrider H10x Bike, Руководство пользователя

Страница: 22 / 28

22
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt, you must remove the seat
post, the post knob, the top shield, the right pedal, and
the right shield (see the instructions below).
To remove the Seat Post (5), loosen the Post Knob (11)
a few turns, pull the Post Knob outward, and remove
the Seat Post. Then, using an adjustable wrench,
remove the Post Knob.
Using a flat screwdriver, release the tabs along the bot-
tom edge of the Top Shield (9) and slide the Top Shield
upward. Then, using an adjustable wrench, turn the
Right Pedal (26) counterclockwise and remove it.
Remove all the screws from the left and right shields;
there are two sizes of screws in the shields——note
which size of screw you remove from each hole.
Then, gently pull the right shield away from the frame.
Loosen the M6 x 20mm Hex Screw (46). Then, tighten
the M10 x 50mm Hex Screw (33) until the Drive Belt
(23) is tight.
When the Drive Belt (23) is tight, tighten the M6 x
20mm Hex Screw (46).
Then, reattach the left and right shields, the right pedal,
the top shield, the post knob, and the seat post.
9
11
26
5
46
33
23