6
5. While another person holds the Handlebar (16) near
the Upright (6), connect the two Pulse Wires (22) to
the corresponding wires on the Console (9) (refer to
the inset drawing).
Next, attach the Handlebar (16) to the Upright (6)
with three M8 x 45mm Button Screws (17) and three
M8 Curved Washers (28).
Make sure that the
Pulse Wires (22) are not caught between the
Handlebar and the Upright.
6. Attach the Cup Holders (14) by firmly pushing them
down into the indicated holes in the Upright (6) until
they are seated fully.
If there is a vinyl film covering the pulse grips, peel it
off.
14
14
6
6
4. The Console (9) requires two ÒAAÓ batteries (not
included); alkaline batteries are recommended.
Refer to drawing A. Remove the four indicated
screws and lift off the front of the Console. Press two
batteries into the battery holder as shown in drawing
B. Make sure that the negative (Ð) ends of the bat-
teries are touching the springs. Re-attach the front of
the Console.
Make sure that the three wires are
extending from the back of the Console.
While another person holds the Console (9) near the
Upright (6), connect the Extension Wire Harness (18)
to the console wire harness.
Set the Console (9) on the Upright (6). Tighten four
Console Screws (20) into the Upright and the
Console.
4
Screws
Batteries
Battery
Holder
B
A
9
Console
Wire
Harness
6
20
20
18
17
28
22
16
6
5
Console
Wires
Pulse
Grips
9
A
