P/N UMPELSTARONE_REV20181220
12
WIRELESS COMMUNICATION - Step 3
NOTE: THE SERIAL NUMBER ON THE USB WIRELESS DONGLE MUST MATCH THE
SERIAL NUMBER ON THE YELLOW LABEL OF THE HOMBT1 SCALE UNIT TO
ENABLE ACTIVE WIRELESS COMMUNICATION.
1.
Power on the scale and either the Welch Allyn monitor or PC. To check that the HOMBT1 scale
unit has established wireless communication, observe that the status LEDs are illuminated as in
the figure below.
Note: When attached to the scale you will be viewing the device upside down.
Wireless Status LED
Solid Blue
= Active
Communication
Blinking Blue
= NO
Communication
Power LED
Solid Red
= Active Power
Blinking Red
= Power
Supply Low*
Off
= No Power*
SERIAL NUMBERS MUST MATCH
TO ENABLE WIRELESS
COMMUNICATION.
HOMBT1 SCALE UNIT
USB WIRELESS DONGLE
