Health in motion INSPIRE DUAL AB BACK, Руководство по сборке и эксплуатации

Страница: 15 / 31

Page 12
Step 14: Attach the Shroud Plate Support to the
1 – M8 x 100 Hex Bolt
Main Frame using: 2 – M8 Flat Washers
1 – M8 Locknut
Step 15: Route end of Weight Stack Cable up and over Pulley 2, then over and down Pulley 1. Attach the
Slotted Cable Bolt to the end of the Cable, screw on Jam Nut, and thread the Cable Bolt
completely into the Selector Stem.
Fully tighten the Jam Nut now. Next, thread the Front
Cable Bolt with Jam Nut into the Cable Connector five turns so the end of the bolt is visible
through the inspect holes in the Cable Connector.
Fully tighten the Jam Nut now. Route the
Cable down under Pulley 3, through the Base Frame to the first opening in the tube. From Pulley
3, go straight through and loop around Pulley 4. Make sure that the cable is between Pulley 4
and the Cable Retainer Pin. Continue to route the Cable around Pulley 5 and up around Pulley 6
and install the “U” Bracket Assembly and attach directly to Revolving Straight Bar, no Spring
Clip.
Jam Nut
Cable
Selector Stem
Step 15
Step 14
1 - M8 x 100 Hex Bolt
2 - M8 Flat Washers
1 - M8 Locknuts
Shroud Plate Support
Cable Routing
Cable Retainer
Pulley 2
Pulley 1
Pulley 3
Pulley 4
Pulley 6
Pulley 4 Pulley 5
Pulley 5
“U” Bracket Assembly
Main Frame
Inspect Hole
Front Cable
Weight Cable
Thread bolt completely into selector
stem and tighten jam nut
Front Cable GM886-500-001
Cable
Connector
Weight Cable p/n GM885-500-003
AB BACK CABLE CHART
Front Cable p/n GM886-500-001
Back Cable p/n GM886-550-002
Cable lengths are in millimeters and for reference only.
Cable lengths could change at any time without notice.
Remove Jam Nut and Slotted Bolt from
Cable before installing Cable Assembly
3155 mm
1416 mm
4980 mm
Revolving
Straight Bar
NOTE: Wrench Tighten Steps 2, 9, 10, 11, 12, 13, and 14.
Now.
Remove Jam Nut and Slotted Bolt from
Cable before installing Cable Assembly
4635 mm
1416 mm
6445 mm
AB BACK CABLE CHART
Cable lengths are in millimeters and for reference only.
Cable lengths could change at any time without notice.
Back Cable p/n GM886-550-002
Weight Cable p/n GM885-500-003
Front Cable p/n GM886-500-001
Weight Cable GM885-500-003