- 3 -
Sensor threshold:
Sensitivity (threshold) can be adjusted precisely to your riding style. Adjust this number
to cut the ignition at the optimal force on the gearshift lever.
Use the
Sensor logging
feature to find the optimal value (follow the instructions on
the screen, or see the
Troubleshooting
chapter, step 6).
When riding the bike with QSE enabled and doing full throttle clutchless upshifts:
-
If the shift lever is too hard, adjust the threshold LOWER.
-
If you experience unwanted cut-offs e.g. when touching the shift lever lightly, adjust
the threshold HIGHER.
Note:
Engine cut-off is disabled under the First RPM value. When using an NC/NO
switch, refer to the instructions received with your sensor.
First RPM:
This will be the first RPM number on the main screen.
Engine cut-off is disabled under the First RPM value, so we recommend setting it well
above idle speed to ensure the engine won’t stall when you put the gearbox in first
gear.
Last RPM:
This will be the last RPM number on the main screen.
Enter the RPM number where the red zone starts on your tachometer.
The ignition will be cut-off for the duration set by the last RPM row if the shift occurs
above that RPM.
Cut-off delay:
Increase this value only if the cut-off happens too quickly AND you can’t adjust the
Sensor threshold further. Normally leave it at zero.
Cut-off test:
When the engine is running, you can test whether the engine cut-off function works
normally or not.
Allow cut-off when RPM is falling:
If checked, you may do clutchless downshift with partial throttle from the higher gears.
The sensor must be installed under the bolt (not in the rod) to detect both directions.
Caution: Use with care! If the downshift is not smooth on your bike, use the clutch!
Use normally open output:
If you connect the QSE to the ignition coils or injectors, leave this option unchecked.
Note:
This parameter is available only with the QSE-2 module.
PIN code:
You can setup a personal PIN code (1 to 4 digit long) to make sure no one else has
access to your module. If you replace your phone or connect from another phone, you’ll
have to enter the PIN code at the first connection.
Beware, if you forget your personal PIN code, you’ll have to return the module to us to
clear it.
If you wish to disable the PIN code protection, enter the current PIN and leave the new
PIN fields blank.
Note:
The PIN code is not related to the Bluetooth pairing code.
Sensor type:
Select whether you use the QSE sensor or a standard push or pull QuickShifter sensor
from a different manufacturer, such as the
Nextup
switch.
You may also use a handlebar mounted switch, like the passing light switch to trigger
the cut-off when racing rules do not allow a foot operated QuickShifter.
