- 2 -
9.
Set the engine cut-off times on the main screen
for different RPM ranges.
Start with the default cut-off times and adjust if necessary. If your bike has less
than 4 cylinders, typically larger values are needed. If the gearbox makes a strange
noise or does not take a gear, increase the values. If the gearshift is smooth but
not quick enough, reduce the values.
Do NOT go below the default cut-off times unless you are a racer and you know
what you are doing. It is safer to use larger values than smaller.
10.
After making the desired changes and you wish to store it in the module, press
Menu
→
Upload
. When the module is connected next time, the settings will be
loaded automatically to the app from the module (even if you replace your phone).
You can store and recall your favorite settings by pressing
Menu
→
File
.
Note: While the module is connected, it always responds to a change in the
application. However, if you turn off the ignition key before tapping on Upload, the
module will revert back to the previous settings.
3.
LED status codes
Solid RED
Unit is powered up.
Engine is not running or RPM signal is not received.
Solid GREEN
Unit is powered up.
Engine is running (RPM signal is received).
Flashing RED
Error detected.
Connect to the application to see the problem.
Flashing
GREEN
Bluetooth interface is in standby (typically, while riding).
Stop the engine if you wish to connect.
Inverse color
Shift signal detected, data is sent to the module or firmware
update is in progress.
4.
Settings menu in the app
Bypass mode (disable QSE):
Check this option if you wish to disable the QSE module.
Engine speed:
Shows the actual RPM detected by the module. Check and make sure it is in sync with
the tachometer of your bike. Otherwise, change the
Pulses per rev
number here.
Sensor current / maximum value:
Shows the current and maximum readings from the QSE sensor.
The harder and quicker you make a gearshift, the larger number you see.
Note:
This parameter is not available when an NC/NO switch is used.
Switch status:
Shows the status (
On
or
Off
) when a standard (
Normally Closed
or
Normally Open
)
switch is used.
Note:
This parameter is not available when the QSE sensor is selected.
