HE-VA Disc-Roller Contour, Руководство по эксплуатации

Страница: 11 / 72

Disc-Roller Contour 4,5 – 5,5 – 6,5 m 20-09-2020
11
Back to the table of contents
Put the machine on level ground
and relieve the hydraulics, before
leaving the machine.
Transport
1. Lift the discs to the top before folding up the machine.
2. Then lift the machine to maximum transport height.
3. Fold up the side sections (blue) towards the stop on the centre frame, and the
locking claw will engage
. It is important to check visually that the locking
claw is engaged. The hydraulic system must then briefly be put in the float
position after the locking pawls are engaged, until the locking claw has
relieved the hydraulics.
4. Now the machine is secured and ready for transport.
5. Lower the machine in order to minimise the transport height, to get a point of
gravety as low as possible. Slow and gentle cornering is recommended as
otherwise the machine is at risk to tip over.
Uncoupling, Mounted Model
1. Put down the machine on firm ground and relieve all hydraulic hoses.
2. Now the machine may be uncoupled.
Uncoupling, Trailed Model
1. Lift the machine up and tilt the depth stop on the drawbar forward towards
the tractor.
2. Now lower the machine onto firm ground.
3. Adjust the drawbar – and wheel cylinder (red) so that the drawing bolt is
loose.
4. Now the machine may be uncoupled.
5. Drive the tractor a little forward and then relieve all hydraulic hoses.
Important: