HDL HDL-MTIRW, Руководство пользователя

Страница: 7 / 16

User Manual
MTIRW IR/RF Remote Controller
Remote Controller – User Manual
4
When the process is complete the 2 nd page of the DLP panel will not be visible on the
menu of the Remote Control.
3.2 IR code learning
Steps ：
a) Enter the IR code learning interface, see Fig.3
b) Point the front of the remote controller 1-2cm away from the front of the 3 rd party
remote controller.
c) Press the relevant button on the 3
rd
party remote controller that you wish your HDL
controller to learn. If the operation is successful the remote will display “Learn OK, Key
enter try code”, If the operation fails, the display will show “Learn interfere, try again”.
d) Test Code: Check that the code has been learnt successfully, Press Test Code to
return to the previous menu.
3.3 RF address setting
Each RF Remote Controller has an address, the address range is 1~65534.
You can set up to four "receiving address" in each RF receiver, correspondingly, the RF
receiver can receive control commands from four matched RF Remote Controllers.
Fig.3 IR code learning
IR code
learning
interface
Fig. 4 RF remote controller’s address setting
RF remote controller’s
address