— 21 —
2: AM hybrid/all digital dual-stream
3: FM all digital dual-stream with stereo core
10: FM dual-stream on SPS
13: FM hybrid/all digital single-stream
Split Mode:
allows the user to make a rough audible
check of timing synchronism between the analog FM and
digital HD1 program channels. This is normally set
Off
, but
can be turned
On
to route a monaural version of the HD1
program to the left audio channel, and monaural FM pro-
gramming to the right channel. FM and HD Radio audio lev-
els may be compared with the LCD level meter as well in
this mode. After using this utility, be sure to turn it back
Off
to ensure proper operation of the INOmini 639.
De-Emph:
displays the current setting for FM program au-
dio de-emphasis.
75us
(75 microseconds) is used in the
Western Hemisphere, and
50us
for the rest of the world.
Push and turn the knob to change this selection.
Highlight and enter
Region
to load the proper list of pre-
defined RDS PTY classifications. Set this to
NA RBDS
for
North America, or
EU RDS
for Europe and most of the rest
of the world. If you operating outside of the US, Canada or
the European Union, consult the appropriate Radio Authori-
ty to verify a proper choice.
The three rear-panel alarm tallies are NPN transistors that
normally saturate to ground for the
C
(Carrier loss)
D
(HD
Radio Digital loss) and
A
(Audio loss) rear-panel alarm tal-
lies. This is the default setting: a ground on the rear-panel
connector when the alarms are active.
Alarm Polarity:
may be reversed, however, so that the terminal will normal-
ly sit at ground and go open for an alarm. Push the knob to
cycle through the three alarms and set the polarity accord-
ingly. For example:
A:G
gives a ground when audio is lost;
A:O
an open-circuit for dead air.
The
Load Defaults?
Menu screen will reboot the INOmini
639 and reset all setup choices to factory-default values.
Push and turn the knob to bring up
Yes
on the second line,
and push the knob again to complete the task.
If you are in a hidden menu that can be edited, you must
navigate back to the first,
639 Firmware
screen and push
the knob to exit the hidden menu area.
— 22 —
Section IV
USING THE ANALYSIS SOFTWARE
Installing the Software
The analysis and logging software should be installed be-
fore connecting the INOmini 639 to your computer.
Installation is a simple Windows Installer (.msi) routine dis-
tributed on the CD-ROM packaged with the INOmini 639.
This small file may also be downloaded from the Inovonics
Website.
You may install directly from the CD-ROM, or
download the .msi file to the Windows Desk-
top where it will regenerate the icon shown
here. Double-click the icon to start the instal-
lation.
The initial installation
screen is a
Welcome to
the RDS HD Radio Logger
Setup Wizard
. Click:
Next
to bring up this second
screen. Here the install-
er suggests a Program
File location. Unless you
have a specific issue, ei-
ther with this or with the
privileges
selection,
simply accept the de-
faults and continue to
click:
Next
.
The installation should proceed and com-
plete flawlessly, placing this program short-
cut icon on your Windows Desktop.
At this point, connect the INOmini 639 to a
USB port of your computer, using the cable
provided. Then double-click the icon to
launch the INOmini 639 analysis and logging
utility.
