HCO
3-Advanced Setting SG550/SG530
Page 15
（
b
）
(2)
（
c
）
(3)
Figure 11: Setting video length
3.1.8 Trigger Interval Time Between Two Triggering
The trigger interval time means how long the PIR will be disabled after each trigger. When a
trigger occurred, the triggering object, e.g., an animal might stay or move within the scope for a
long time. This might lead to the next trigger within a short time again. The interval time is set
to prevent this. This parameter is only valid for the LIVE mode. It has 120 values, from 0 to 59
seconds (with the increment of 1 second) and from 1 to 60 minutes (with the increment of 1
minute). The default value is 1 minute (60 seconds). Press the RIGHT key to change the value
by one second or press the RIGHT key and hold for a few seconds, the value will be increased
by 5 seconds or 10 seconds.
1
In MENU, press the UP or DOWN key until “Interval” appears, as shown in Fig. 12(a)
and 12(1).
2
Press the RIGHT key until the desired value appears, as shown in Fig. 12(b) and 12(2).
3
Press the OK key to save or press the MENU key to cancel and exit. After pressing the
OK key, the selected value will no longer be highlighted, as shown in Fig. 12(c) and
12(3).
(a)
(1)
(b)
(2)
