Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
Page 12 / 18
BE-514_I-V1-3-FCC.doc.doc [ Word 2000 ] MB
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
30-04-2003
Information and specifications subject to change without notice.
Radio System
3.1
Radio Status Panel
The control display with LEDs indicating the operating state of the radio system is
located behind the inspection window of the receiver cover lid.
The LEDs have the following significance :
Ein / On / Marche / Acceso
(yellow) is illuminated as soon as operating voltage is
present at the receiver, i.e. the connection to the electronic of the crane or machine is
established and operating voltage (12 V) is present.
HF / RF / H.F. / HF
(red) is illuminated whenever the transmitter is switched OFF. It will
be extinguished the very moment a signal is received by the receiver on its radio
frequency.
Note :
–
Should the "HF/RF/H.F./HF" LED be extinguished while the transmitter is switched
OFF, then this indicates that the radio channel is also utilized by another transmitter.
– In the case of a switching OFF of the electronic system as a result of radio
interference it is recommended for you to also switch OFF your transmitter and
monitor if the "HF/RF/H.F./HF" LED is extinguished nevertheless.
Exception :
With radio systems that are equipped with a frequency selector function (optional),
the "HF/RF/H.F./HF" LED will either extinguish or flash. This indicates that the
receiver is searching (scanning) the stored frequencies available for its specific
transmitter.
SI 1
(green) is flashing approx. twice per second when the transmitter is switched OFF.
During this time, the safety circuit will be checked.
The "SI 1" LED permanently illuminates after the transmitter is switched ON, i.e. the
receiver has identified its specific transmitter on the basis of the common message
address (code). Safety circuit SI 1 is enabled.
SI 2
(green) refers to the internal safety circuit SI 2, responsible for a double switching
OFF of the move commands whenever the control station is in the OFF (ZERO) position,
i.e. "SI 2" will not be illuminated.
It is not until one or several drive commands (e.g. turn, trolley traveling, lifting gear or
crane traveling) are input that the "SI 2" LED may be illuminated !
gelb
yellow
jaune
giallo
Ein / On /
Marche / Acceso
rot
red
rouge
rosso
grün
green
vert
verde
grün
green
vert
verde
HF / RF /
H.F. / HF
Si 1
Si 2
