Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
Page 10 / 18
BE-514_I-V1-3-FCC.doc.doc [ Word 2000 ] MB
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
30-04-2003
Information and specifications subject to change without notice.
Radio System
3
Installation and Mains Connection
Warning – shock hazard!
!
Only skilled and qualified persons may connect the radio receiver to the mains
supply.
!
Mains connection must be performed in accordance with the enclosed output wiring
instructions. Take technical data into due consideration !
!
Various components within the radio receiver housing conduct electricity. Contact to
these components as well as to mains voltage is hazardous !
The radio receiver FSE 514 is to be mounted using the rubber vibration dampers
(included). The rubber vibration dampers are to be screwed to the mounting loops on the
upper and lower edge of the receiver
ℑ
.
The radio receiver is connected to the crane or machine electronics through the heavy-
threaded compression gland
ℜ
.
The radio receiver lid may be removed for commissioning the system.
Note:
– To avoid damaging components, the commissioning of the radio control system
should only be carried out by skilled and qualified personnel with expert knowledge
of electronic components (confer section 2.3 for further information).
–
Before activating the radio control system, study the description and instructions for
using the radio status panel
ℵ
.
