16
^
hazet.com •
]
Immer persönliche Schutzausrüstung tragen!
Always wear personal protective equipment!
• Press the operating lever to operate the
tool.
• Release the operating lever to stop the tool.
• Please note that the tool still carries on
running after the operating lever has been
released.
• The direction of rotation is controlled via
the changeover switch on the rear of the
housing; two-stage forward rotation, single-
stage reverse rotation
• After completing the operation, switch off
the compressor and store it in accordance
with the operating instructions of the com-
pressor.
• Only use clean and dry air at a max. pres-
sure of 90 PSI or 6.3 bar. Dust, flammable
vapour and high humidity can result in dam-
age to the pneumatic tool's motor.
• Do not remove any stickers and replace
damaged stickers.
• Keep hands, loose clothing and long hair
away from the tool's moving part.
• Maximum efficiency due to the ground-
breaking HAZET Twin Turbo technology
enables high torques with compact design
• Innovative 8-blade air motor with 25%
higher impact performance ensures maxi-
mum torque.
• Long service life and high efficiency in
industrial and automotive applications.
• Compact design, optimised for work in
confined spaces
2. Before starting the operation
The pneumatic tools must
always be used, inspected and
maintained in compliance with
the local government, state or
federal regulations.
• Drain the compressor tank and remove the
condensate from the air lines. Carefully read
through the operating instructions for the
compressor.
IMPORTANT:
We recommend using air filters and
a compressed air line lubricator.
CAUTION!
Disconnect the compressed air sup-
ply prior to lubricating, connecting or
disconnecting the tool.
• Lubricate the tool; see the section on mainte-
nance in these operating instructions.
• Remove the dust cap on the compressed air
inlet.
• Connect the tool to a hose of suitable size.
Table on page 15.
3. Commissioning
• Switch on the compressor so that the air
tank can be filled.
• Turn the compressor regulator to approx.
90 PSI or 6.3 bar. The max. working pres-
sure of this tool is approx. 90 PSI or 6.3 bar.
• The power may vary depending on the size
of the air compressor and the volume of the
compressed air output.
• Do not use damaged or worn air hoses or
adapters of inferior quality.
• The technical data provided refer to an
operation of the tool at a pressure of 6.3 bar.
• Caution is required at all times when using
the tool. Negligent operation may cause
damage to the inner parts or the housing
and limit the working performance.
3
Design and function
Twin Turbo
2 x exhaust inlet
4 x exhaust outlet
