OPERATION INSTRUCTIONS AND
IMPORTANT INFORMATION
READ BEFORE USING THE CLEANER
OPERATING CONDITIONS
CAUTION - RISK OF EQUIPMENT DAMAGE
• Do not operate outside the pool. This will damage the motor
seal and void the warranty.
• Do not drag the cleaner out of the pool against the side wall.
This could damage the cleaner and/or the pool wall.
• Only operate the cleaner for the period of time necessary to
clean the pool. Excessive use is unnecessary and will cause
cleaner parts to prematurely wear.
• Regularly inspect the cleaner, cables and control unit. Do
not use if damaged or if any rough edges are visible on the
cleaner. This can cause damage to the pool.
• Cleaner filter cartridges or debris canister should be
thoroughly cleaned after each use or as often as needed to
ensure the cleaner’s optimal performance.
• Never store the cleaner with dirty filter cartridges
or debris canister.
• Water temperature operation range: min 50°F / 10°C,
max 95°F / 35°C. Maximum operating depth: 3 m (10 ft.)
• Operating the cleaner in temperatures above or below this
range may affect performance, and cause premature
wear or failure.
• Ambient air temperature: max 104°F / 40°C.
• To protect from permanent damage, if the cleaner is exposed
to extremely hot ambient temperature, the power-supply will
limit or suspend operation until its temperature is down to an
acceptable operating level. To limit overheating and reduced
performance, it is recommended to keep the control unit out
of direct sunlight and keep the cooling fan unobstructed.
BOX CONTENTS
UNPACKING
• Operation instructions and warranty pack with product
information (serial and model number)
• Accessory pack
• Cleaner with cable
• Control unit
• Carefully remove the contents of the box from the top.
Do not put the box on its side to remove content as some
parts may fall out of the box and get damaged.
• Verify the contents of the box.
• Carefully read the operation instructions and warning
document first.
Unpacking and Cleaner Preparation
