USE ONLY HAYWARD® GENUINE REPLACEMENT PARTS
2
IMPORTANT SAFETY INSTRUCTIONS
Before installing or servicing this electrical equipment, disconnect it from the power supply
WARNING
Read and follow all instructions in this owner’s manual and on
the equipment. Failure to follow instructions can cause severe
injury and/or death
WARNING –
This manual contains important information about the installation, operation, and safe use of this pump
that must be transferred through to the end user of this product.
WARNING –
This product should be installed and serviced only by a qualified professional.
WARNING –
All electrical wiring MUST be performed by a qualified electrical contractor, and must conform to Local/
State/Federal electrical regulations and the Latest Edition of AS/NZS 3000 Wiring Rules.
WARNING –
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilites, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY
DO NOT PLAY WITH THE APPLIANCE.
CAUTION –
This pump is intended for use on permanently installed swimming pools and may also be used with hot
tubs and spas if so marked. Do NOT use with storable pools. A permanently installed pool is constructed in or on the ground
or in a building such that it cannot be readily disassembled for storage. A storable pool is constructed so that it is capable of
being readily disassembled for storage and reassembled to its original integrity. Though this product is designed for outdoor
use, it is strongly advised to protect the electrical components from the weather. Select a well-drained area, one that will
not flood when it rains. It requires free circulation of air for cooling. Do not install in a damp or non-ventilated location. If
installed within an outer enclosure or beneath the skirt of a hot tub or spa, adequate ventilation and free circulation of air
must be provided to prevent overheating of the motor.
WARNING –
Pool and spa components have a finite life. All components should be inspected frequently and replaced
at least every ten years, or if found to be damaged, broken, cracked, missing, or not securely attached.
WARNING –
Risk of Electric Shock
. All electrical wiring must be performed by a qualified
electrical contractor, and must conform to Local/State/Federal electrical regulations and the Latest
Edition of AS/NZ 3000 Wiring Rules.
All electrical circuits must be supplied through a Residual
Current Device - RCD (Safety Switch), with a residual operating current not exceeding 30 mA
.
Hazardous voltage can shock, burn and cause death or serious property damage. To reduce the risk of
electric shock, do NOT use an extension cord to connect unit to the electricity supply.
WARNING –
To reduce the risk of electric shock replace damaged wiring immediately. Locate the power cord so that
it cannot be damaged by lawn mowers, hedge trimmers and other equipment.
WARNING –
Never operate the circulation system at more than 344 kPa (50 PSI) maximum.
WARNING –
Automatic Restart.
The pump motor is automatically protected from overheating. If such an error
occurs, the pump will automatically restart once the temperature is at a safe level to do so without warning. If a power
failure occurs while the pump is running, it will automatically restart once the power has been restored.
