USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 12
Salt & Swim
™
3C
CELL LIFE LOW
: Illuminates when cell has reached the end of its expected life.
PROBLEM DETECTED
: When this LED indicator is illuminated, there is a problem with
the unit. Refer to the Troubleshooting section of this manual.
STANDING BY
: Illuminates when unit is waiting for the filter pump to turn on or is in-between
generating cycles as part of normal operation to maintain selected daily chlorine output.
GENERATING CHLORINE:
Illuminates when unit is actively generating chlorine.
SUPER CHLORINATING:
Illuminates when unit is super chlorinating.
INADEQUATE WATER FLOW:
Illuminates when there is no flow or low flow through the cell.
The pool filter pump could be in its “off” cycle. If this is not the case, refer to the Troubleshooting
section in this manual. Blinks when performing the Flow Switch Calibration procedure.
DAILY CHLORINE OUTPUT:
Press ( + ) and ( - ) to increase or decrease the chlorine
generation. The
DAILY CHLORINE OUTPUT
LEDs above these buttons will indicate the
relative amount of chlorine being generated.
SUPER CHLORINATE:
When you have an abnormally high bather load, a large amount
of rain, a cloudy water condition, or any other condition which requires a large amount of
purification to be introduced, press the “S” button. This electronically “
super chlorinates
”
(boosts chlorine generation output) the water for 24 hours (filter pump must be on during
this time). To cancel super chlorinating, press the “S” button again.
Controls
The main controls and indicators are shown below.
