Hayward HeatPro, Руководство пользователя, Страница: 14 / 43

Heat Pump Pool / Spa Heater Owner’s Manual
13
Cleaning Procedures
•
Disconnect power to the unit
(usually at the circuit breaker in
your house). Verify that power is
off by checking the display for
lights. If no lights are present,
proceed to the next step.
•
Remove the fan guard by removing
(4) acorn nuts that retain the fan
guard. DO NOT REMOVE THE
NUTS THAT RETAIN THE FAN
MOTOR.
•
Using a water hose and spray nozzle, direct water through the evaporator coil fins
to flush out debris. Spray from inside the unit to push debris out. Never spray
from the outside, as this will lodge debris in the evaporator coil fins. Keep nozzle
back 12-18 inches from the evaporator coil surface to prevent deforming the fin
surface.
NOTE: Do not aim a water stream directly at the fan motor.
•
Use a rag to remove build-up from the fan blades and the fan motor.
•
If necessary, use a shop-vac to remove debris from the base pan and other areas of
the unit.
•
Replace the fan guard and acorn nuts, securing them tightly.
•
Use a rag and soapy water to clean the external plastic panels of the unit. DO
NOT wipe across the evaporator coil fins, as this will deform them and affect
operational efficiency. Instead use a very soft-bristle brush to gently loosen grit
and grime that may have collected.
•
Reconnect power to the unit and ensure it is operating correctly.
Beginning of season
•
Perform the cleaning procedures recommended above.
•
Be certain the water lines and the heat pump are reconnected and / or drain valves
are closed.
•
With the pool heater power off , start the pool filter pump. Check for possible
water leaks and be certain there is adequate water flow: 30 – 75 GPM.
•
Complete your normal preparation and / or cleaning of the pool for the start of the
season.
•
Turn the heat pump power on and set the thermostat to the desired temperature.
TIP: Setting the thermostat to its highest setting will not heat the water any faster
than setting the desired temperature point.
Fan Guard
Acorn Nut
Fan Motor
Mount Nut