USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
5
3) Assemble the included tool shown below. After assembly, insert the tool’s tabs into the light
face and handtighten until snug. Do not overtighen.
Plaster
Install the plaster shield onto the face of the ColorLogic/CrystaLogic 1.5” LED light before plastering
the pool walls. The shield is used to prevent gunite/plaster from coming in contact with the light face
and lens. Do not plaster over the light shield. Remove the shield when gunite/plaster has fully cured.
Install Junction Box or Junction Box Transformer
When using a wallmount low voltage transformer, a junction box should be installed to make the con-
nection to the pool/spa light. If using more than one light, an adequate amount of single or double
outlet junction boxes will be required. Alternatively, Hayward low voltage junction box transformer
kits (LTBUY11H65) can be used when in-line transformers are desired. Refer to page 8 for more
information.
Junction boxes must be installed not less than 48 inches (1.22 m) from the edge of the pool or spa.
Run conduit from the mounting location up to the junction box such that the junction box is not less
Hold handle steady while
rotating knob until snug
Install shield before plaster
Remove after plaster has cured
