Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Use of non genuine Hayward manufactured parts will void all warranty.
Troubleshooting Guide
K487BLU REV A
20
Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Use of non genuine Hayward manufactured parts will void all warranty.
… … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … ….
Problem: Cleaner climbs to water surface and sucks air
CAUSES
SOLUTIONS
Too much water flow through cleaner
Check water flow with flow gauge and adjust per instructions in
Step 6 of installation instructions.
Improper tension on rear flap
Turn rear flap adjuster to number I setting. If still climbing too
much, reduce water flow until proper operation is achieved
Steering failure
1) Clean all debris off of rear screen
2) Check to see that cone gear rotates smoothly in both
directions
3) Check gear box assemblies for proper operation
… … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … ….
Problem: Cleaner head floats
CAUSES
SOLUTIONS
Air trapped inside cleaner head
Remove all air from cleaner head as described in installation
instructions
The cleaner head is being pulled or lifted off
If cleaner head and hose are covered with fine bubbles, lightly
the bottom of the pool by the cleaner hose.
shake them back and forth to release the air bubbles and allow
the cleaner head to settle to the bottom of the pool.
To prevent the more air bubble from attaching to the head and
hose, it is necessary to stop all air from entering the pool through
the return lines.
Adjust the return fittings down to prevent water flow from pushing
the hoses on the surface of the pool.
220318_BluManual_r3.indd 20
1/14/13 1:27 PM
