Hayward Pool Products S180T PRO Series, Руководство пользователя

Страница: 7 / 8

Page 7 of 8 MODEL S180T, S180T90 IS180T90 Rev C
WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
WINTERIZING
1. Completely drain tank by unscrewing drain cap at
base of filter tank. Leave cap off during winter.
2. Depress Vari-Flo control valve handle and rotate so
as to set pointer on valve top between any two
positions. This will allow water to drain from the valve.
Leave valve in this "inactive" position.
3. Drain and winterize pump according to pump
instructions.
SERVICE & REPAIRS
Consult your local authorized Hayward dealer or service
center. No returns may be made directly to the factory
without the expressed authorization of Hayward Pool
Products, Inc.
PLEASE REALIZE:
Pure, clear swimming pool water is a combination of two
factors
—adequate filtration and proper water chemistry
balance. One without the other will not give the clean
water you desire.
Your filter system is designed for continuous operation.
However, this is not necessary for most swimming pools.
You can determine your filter operation schedule based
on your pool size and usage. Be sure to operate your
filtration system long enough each day to obtain at least
one complete turnover of your pool water.
To properly sanitize your pool, maintain a free chlorine
level of 1 to 3 ppm and a pH range of 7.2 to 7.6.
Insufficient chlorine or an out of balance pH level will
permit algae and bacteria to grow in your pool and make
it difficult for your filter to properly clean the pool water.
PROBLEM SOLVING LIST
LOW WATER FLOW SHORT FILTER CYCLES POOL WATER WON'T CLEAR UP
REMEDY 1. Check skimmer and pump 1. Check for algae in pool and 1. Check chlorine, pH and total
strainer baskets for debris.
2. Check for restrictions in
intake and discharge lines.
3. Check for air leak in intake
line (indicated by bubbles
returning to pool).
4. Backwash filter.
superchlorinate as required.
2. Be sure chlorine and pH
levels are in proper range
(adjust as required).
3. Check surface of filter sand
for crusting or caking
(remove 1 " of sand if
necessary).
alkalinity levels and adjust
as required.
2. Be sure flow rate through
filter is sufficient.
3. Operate filter for longer periods.
4. Be sure Vari-Flo valve is set
on "Filter" position.
SUGGESTED POOL CHEMISTRY LEVELS
pH 7.2 to 7.6
TOTAL ALKALINITY 80 to 120 ppm
CALCIUM HARDNESS
200 to 400 ppm
COMBINED CHLORINE
0.2 ppm Maximum
CHLORINE (STABILIZED) 1.0 to 3.0 ppm
CHLORINE STABILIZER
(Cyanuric Acid)
60 to 80 ppm