Hawk HA-FM11, Руководство пользователя, Страница: 6 / 40

Locations for the HAWKGUARD shock sensor
Some things to remember about where to mount the shock sensor:
• Never put the shock sensor in the engine compartment!
• Find a spot close to the control module so that the wires to not need to be
extended. Keep it away from the heater core (or any other heat sources) and
any obvious leaks.
How the shock sensor is mounted is the most important factor in its
performance. We recommend 2 methods:
• using double-sided tape or hook-and-loop fastener to mount to a trim panel
or an air duct, or
• Wire-tying to a wire harness.
Locations for the HAWKGUARD Ultra Sonic Sensors
Ultrasonic cells should be placed on the left and right side
as high as possible so to obtain the best performance.
Inappropriate adjustment for the Ultrasonic sensor may let to a false alarm. To
prevent the false alarm, make sure the sensibility of ultrasonic sensor is in an
appropriate degree. An over adjustment is usually the main reason to cause
false alarm.
Locations for the Immobiliser relay
If Immobiliser relay or its connections are immediately visible upon removal of
the under-dash panel, they easily can be bypassed. Always make the relay and
its connections difficult to discern from the factory wiring! Exposed yellow
butt connectors do not look like factory parts, and will not fool anyone!
For this reason, routing the Immobiliser relay wires away from the steering
column is recommended.
HA-FM11 manualv3_p1-20_Layout 1 15/08/2016 18:40 Page 6