SERVICE INFORMATION
To obtain consistent performance over the life
of your equipment, read through these instruc-
tions and save them for future reference. If you
require service, contact the dealer from which the
machine was purchased or an authorized service
station. Always refer to your Limited Warranty for
complete service information.
The model, type, and serial number are indicated
on the data plate on the side of the handle. For
prompt and complete service, refer to these num-
bers when inquiring about service.
IMPORTANT SAFETY INSTRUCTION
When using an electrical appliance, basic precau-
tions should always be followed, including the
following:
READ ALL INSTRUCTIONS BEFORE US-
ING THIS FLOOR MACHINE.
l
Your floor machine is equipped with a safety
switch lock and power switch triggers de
signed for your safety. Do not attempt to by
pass or defeat the safety switch lock. Never
use any device to lock the power switch trig
gers in the “ON” position.
l
Do not leave the floor machine plugged in.
Turn off the switch and unplug the
electrical cord when not in use and before
servicing or changing the brushes or pads.
SERIAL NO.
MODEL
VOLTS
MOTOR
PHASE
AMPS
HZ
H.P.
Write the model and serial number of your
unit in the space provided. Refer to the
data plate on unit.
SERIAL #
MODEL #
Retain this owners manual for future reference.
WARNING: ELECTRIC SHOCK
CAN CAUSE SERIOUS INJURY OR
BE FATAL. PLEASE READ THE
FOLLOWING INSTRUCTIONS
ON THE USE AND
OPERATIONS OF FLOOR
FINISHING MACHINES.
l
Do not allow the machine to be used as a toy.
Close attention is necessary when used near
children. Do not leave the machine connected to
an electrical outlet unattended.
l
Use only as described in this manual. Use only
manufacturer’s recommended attachments.
l
Do not use with a damaged cord or plug. If the
machine is not working as it should, has been
dropped, damaged, or left outdoors, return it to a
service center before using.
l
Use care to keep the electrical supply cord
around sharp edges or corners. Keep the cord
away from the heated surfaces.
l
Connect to properly grounded (3-wire) outlet
only. Refer to Grounding Instructions, Page 4.
l
Do not use extension cords or outlets with
inadequate current carrying capacity.
l
Turn off all controls before unplugging.
l
Do not unplug by pulling on the cord. To unplug,
grasp the plug and pull.
l
Do not handle the plug or floor machine with wet
hands.
l
Wind the cord no tighter than is necessary to
retain it during storage. Refer to Cord Storage,
Page 5.
l
Use extra care when working on or near stairs.
l
Do not use in conjunction with flammable or
combustible liquids such as gasoline, or use in
areas where explosive vapor or dust may be
present.
l
Store your floor machine indoors in a cool, dry
area.
l
Keep your work area well lighted.
l
WARNING: To avoid electrical shock, use
indoors only.
2
