GROUNDING INSTRUCTIONS
This appliance must be grounded. If it should mal-
function or break down, grounding provides a path of
least resistance for electric current to reduce the risk
of electric shock. This appliance is equipped with a
cord that has an equipment-grounding conductor and
grounding plug. The plug must be plugged into an ap-
propriate outlet
that is properly installed and grounded in accordance
with all local codes and ordinances.
FOR FLOOR FINSIHING MACHINES RATED
LESS THAN 150 VOLTS
Improper connection of an equipment grounding con-
ductor can result in risk of electric shock. Check with
a qualified electrician or service person if you are in
doubt as to whether the outlet is properly grounded.
Do not modify the plug provided with the appliance.
If it will not fit the outlet, have a proper outlet in
-
stalled by a qualified electrician. This appliance is for
use on a nominal 120 volt circuit and has a ground-
ing plug that looks like the plug illustrated in Figure
1. A temporary adapter which looks like the adapter
illustrated in Figure 2 may be used to connect this
plug to a two pole receptacle, as shown, if a prop-
erly grounded outlet is not available. The temporary
adapter should be used only until a properly grounded
outlet (Figure 1) can be installed by a qualified
electrician. The green colored rigid ear, lug, or the
like extending from the adapter must be connected to
a permanent ground such as a properly grounded out-
let box cover. Whenever the adapter is used, it must
be held in place by metal screw.
FOR FLOOR FINISHING MACHINES RATED
150-220 VOLTS:
If the machine is provided with an attachment plug cap
as shown in Figure 3, it is intended for use on a 240 volt
(nominal) circuit. No adapter is available for this cap.
WARNING: DO NOT USE
GROUNDING ADAPTERS ON
FLOOR MACHINES IN CANADA.
CHECK WITH CANADIAN CODES
FOR PROPER EQUIPMENT US-
AGE. IMPROPER USE OF GROUND
ADAPTORS CAN CAUSE SERIOUS
INJURY, FIRE, OR BE FATAL.
OPERATION / ACCESSORIES
CHOOSING THE RIGHT BRUSH AND DRIVE
BLOCK
Your floor machine is packed completely assembled
and ready for use after you install a brush or drive
block.
Your floor machine is designed to be used for many
different floor care applications. Make sure you use
the correct brush or pad for the type of job you want
to perform. (Accessories are available from the dealer
from whom the floor machine was purchased. See
Optional Accessories, Page 10)
When ordering brushes or drive blocks, refer to the
following chart and specify correct brush or block
diameter when ordering.
Machine Size
Pad Driver
Brush Diameter Block Diameter
13”
12”
13”
11”
15”
14”
15”
13”
17”
16”
17”
15”
20”
19”
20”
18”
Clutch plate A0019 is common on all models.
3
