MPS3004 / RS4004 AUDIO SYSTEMS
INSTALLATION GUIDE
HAWG WIRED
PAGE 6
NEWARK, CA
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
[
[
C
C
O
O
N
N
T
T
I
I
N
N
U
U
E
E
D
D
]
]
WIRING THE MAIN AMPLIFIER
SOME BIKES MAY REQUIRE THAT THE GAS TANK BE LOOSENED OR REMOVED TO PROPERLY ROUTE THE POWER WIRE.
PLEASE TAKE EVERY POSSIBLE PRECAUTION NECESSARY WHEN DEALING WITH YOUR GAS TANK! DEFINITELY REFER TO
MANUFACTURER INSTRUCTIONS IF NECESSARY.
6.
ROUTE AND CONNECT THE POWER WIRE (WITHOUT THE IN-LINE FUSE INSTALLED) FROM THE
POSITIVE (+) BATTERY TERMINAL (FIG. 6.A), UNDER THE RIGHT SIDE (PASSENGER, STARBOARD,
ETC.) OF THE GAS TANK, THROUGH THE FAIRING, AND TO THE MAIN AMPLIFIER. THE BLACK
SLEEVE SHOULD END UP COVERING THE EXPOSED POWER WIRE BETWEEN THE GAS TANK AND
THE FAIRING.
WARNING: DO NOT INSTALL THE IN-LINE FUSE UNTIL INSTRUCTED TO DO SO.
NOTE: ON 2006 AND NEWER, WE RECOMMEND UTILIZING THE FACTORY WIRING HARNESS CHANNEL UNDER THE
TANK WITH A SUITABLE WIRE FEEDING TOOL OR DEVICE. USE OF A COAT HANGER IS AT YOUR OWN RISK.
FIGURE 6 – POWER AND GROUND ROUTING AND CONNECTIONS
7.
CONNECT THE GROUND WIRE TO CHASSIS GROUND (FIG. 8.B). TYPICALLY AN EXISTING SCREW
OR NUT ON THE BIKE FRAME SHOULD BE USED, PREFERABLY WHERE A FACTORY GROUND
STRAP ALREADY EXISTS.
TIP: THE MAJORITY OF PROBLEM INSTALLS ARE THE RESULT OF A POOR GROUND. REFER TO “BE WELL
GROUNDED” IN THE INSTALLATION CONSIDERATIONS SECTION FOR MORE INFORMATION.
8.
CONNECT THE MAIN I/O HARNESS. ROUTE AND CONNECT THE REMOTE TURN-ON WIRE FROM THE
AMPLIFIER LABELED REM TO ONE OF THE
FOLLOWING LOCATIONS:
8.1.
FACTORY SOURCE UNITS – TO UTILIZE THE
CIGARETTE LIGHTER METHOD, DISCONNECT
THE POWER TERMINAL FROM THE BACK OF
THE LIGHTER (FIG. 8.A) AND CONNECT IT TO
THE MALE TERMINAL OF THE REMOTE TURN-
ON WIRE (FIG. 8.B). THEN CONNECT THE
FEMALE TERMINAL TO THE LIGHTER
TERMINAL (FIG. 8.C). THIS WILL TURN THE
AMPLIFIER ON/OFF WITH THE IGNITION
SWITCH.
8.2.
AFTERMARKET SOURCE UNITS - REFER TO YOUR SOURCE UNIT INSTRUCTIONS TO
DETERMINE IT’S REMOTE TURN-ON LEAD. THIS WILL TURN THE AMPLIFIER ON/OFF WITH
THE SOURCE UNIT POWER SWITCH.
FIGURE 8 – CIGARETTE LIGHTER METHOD
