KK-K9-C22-K_INST_6-12.docx rev 2-14
Remove screw under door
armrest. (T20 Torx)
Remove / unsnap entire door
panel from door.
(Trim removal tool)
Disconnect latch and lock cables
from door panel.
Remove window switch from door
panel. Remove door speaker.
(T20 Torx)
Remove rear passenger door panels
first.
Underneath door handle, remove
plastic cover and screw.
(T20 Torx)
Note: A small 90° scribe helps to
pick plastic covers off.
Remove screws at bottom of door
panel. (T20 Torx)
Reattach window switch to
original plug. Neatly wire tie the
switch assembly, speaker wire and
latch / lock cables so they do not
interfere with the window
operation.
Double check latch,
lock and window operation
prior to attaching door panel
.
Place K9 kit door panel onto
door. The top will hook onto
rubber molding. Position so it is
centered on the door. Push down
firmly on panel. Drill mounting
holes with 5/32” drill bit. Attach
door panels with #10 x 3/4
Phillips pan head sheet metal
screws.
NOTE:
Window guards are
shipped flat. On the edge of a
work bench, bend a contour in the
middle of the guard so it will
match the window frame contour.
