www.havis.com • 1-800-524-9900
DS-PAN-701
DS-PAN-701-2
DS-PAN-702
DS-PAN-702-2
DS-PAN-703
Before Beginning
(Original Instructions)
2
11
Havis is pleased to provide this Owner’s Manual to aid in the proper
installation and use of the DS-PAN-700 Series Docking Station for
the Panasonic Toughpad FZ-G1.
For questions regarding the set-up of your DS-PAN-700 Series Docking Station,
please contact Havis at 1-800-524-9900 or visit www.havis.com for additional
product support and information.
This Owner’s Manual applies to the following Part Numbers:
• NEVER STOW OR MOUNT THE DOCKING STATION DIRECTLY IN A VEHICLE
AIRBAG DEPLOYMENT ZONE.
• DO NOT USE COMPUTER WHILE DRIVING.
• READ ALL INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION.
• DO NOT DOCK OR UNDOCK YOUR COMPUTER UNLESS IT IS POWERED OFF. DOCKING OR
UNDOCKING WITH YOUR COMPUTER IN ON, STANDBY, HIBERNATION, OR SLEEP MODES
CAN CAUSE PERMANENT DAMAGE.
• FOR THE DS-PAN-701, DS-PAN-701-2, DS-PAN-702 & DS-PAN-702-2 DOCKING STATIONS:
DO NOT CONNECT DIRECTLY TO VEHICLE VOLTAGE SOURCE: This product requires
a certified, automotive grade, Panasonic approved 90W power source rated for a
continuous, regulated 15VDC output
(Havis Part Number LPS-114 or equivalent)
.
Failure to comply with this requirement will cause product damage that is NOT
repairable and is NOT covered under warranty.
• FOR THE DS-PAN-703 DOCKING STATION:
DO NOT CONNECT DIRECTLY TO VEHICLE VOLTAGE SOURCE: The Panasonic FZ-G1 tablet
requires a certified, Panasonic approved power source rated for a continuous, regulated
16VDC output. Panasonic recommends using the power adapter included with the tablet;
failure to comply with this requirement will cause product damage that is NOT repairable
and is NOT covered under warranty.
• FOR DOCKING STATION MODELS EQUIPPED WITH A BUNDLED POWER SUPPLY
(DS-PAN-702, DS-PAN-702-2)
, REFER TO THE SUPPLIED LIND POWER SUPPLY
REFERENCE GUIDE.
• WHEN TABLET IS DOCKED, THE BATTERY WILL ONLY CHARGE BETWEEN
0°C to 50°C (32°F to 120°F).
PLEASE REFER TO PANASONIC TOUGHPAD FZ-G1 OWNER’S MANUAL FOR
MORE INFORMATION.
DS-DA-102 - Havis Night Eyes 2
(USB Powered LED Map Light)
(For further Installation Instructions, refer to the Instructions included with DS-DA-102)
1)
Slide P-Clip over base of Map Light as shown, then line up the mounting
hole on P-Clip with Mounting Hole on Docking Station. Use provided
screw to secure light to the Docking Station.
2)
Plug in USB from Map Light into an available USB Port on the Docking
Station and secure cable as needed with Zip Ties (Docking Station
Hardware Kit Item 1).
Installation of USB Map Lighting
(DS-DA-102 - Optional)
DS-DA-102 provided
mounting screw
DS-DA-102
