background image

WARNING: Changes or modifications which are not expressly approved by HavenLock Inc could void the user’s authority to operate the equipment.

AVERTISSEMENT: Les changements ou modifications qui ne sont pas approuvés par HavenLock Inc pourrait annuler l'autorité de l'utilisateur de faire fonctionner l'équipement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the 

following two conditions:   

       1) This device may not cause interference.

       2) This device must accept any interference, including interference that may cause undesired operation of the device.

Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis 

aux deux conditions suivantes:

       1) Cet appareil ne doit pas causer d'interférences.

       2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil.

This system has been evaluated for RF Exposure per RSS-102 and is in compliance with the limits specified by Health Canada Safety Code 6. The system must be installed at a minimum 

separation distance from the antenna to a general bystander of xx inches (xx cm) to maintain compliance with the General Population limits. 

L’exposition aux radiofréquences de ce système a été évaluée selon la norme RSS-102 et est jugée conforme aux limites établies par le Code de sécurité 6 de Santé Canada. Le système doit être 

installé à une distance minimale de xx pouces (xx cm) séparant l’antenne d’une personne présente en conformité avec les limites permises d’exposition du grand public

This device complies with part 15 of the FCC Rules.Operation is subject 

to the following two conditions: (1) This device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

HAVEN Connect Z

HavenLock Inc

Model:

 HL1-CNT-001-Z

FCC ID:

 2ARFQHL1CNT001Z

IC: 

24389-HL1CNT001Z

Note:

 This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no guarantee that interference 
will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures:

   • 

Reorient or relocate the receiving antenna

   • 

Increase the separation between the equipment and receiver

    

• 

Connect the equipment into an outlet on a different circuit from the one the receiver is connected

   • 

Consult the dealer or an experienced radio/TV technician for help

REGULATORY INFORMATION

NOTICE

To avoid damage to the unit, do not use on wet surfaces or damp locations. The product is designed for indoor 

use only. Do not expose to weather elements as this may affect functionality.

To avoid potential damage to your unit, do not simulate a break in. Damage to the unit may affect later 

functionality.

Owner is responsible for ensuring unit is operating properly. HavenLock Inc expressly disclaims all guarantees, 

whether implied or expressed, to include but not limited to fitness or merchantability for a particular purpose.

CAUTION

Owner is responsible for providing access to your own home. Owner is responsible for ensuring alternate 

access into your home when needed.

Owners are responsible for whoever has access or use to engage or disengage the unit.

 

The unit is designed to act as a deterrent, but should still be used in conjunction with other safety measures. 

The unit is intended as supplementary security for use in conjunction with current lock hardware.

HavenLock Inc is not liable for any personal injuries, property damage, economic loss or any consequential 

damages sustained as a result of any individual in contact with the unit. 

Do not consume any area of the unit. 

Do not put the unit near sensitive bodily areas.

Use caution when placing HAVEN in doorway during installation and use.

 

Owner is responsible for reading and following the operating and safety instructions as well as proper use of unit. 

Wear appropriate protective items during installation to avoid injury.

 

Do not install near live electrical cords. Ensure installation area is free of wires, cables, pipes, and other objects 

that may cause hazards.

 

Use only the tools referenced in the installation guide. Use of other tools or not following installation instructions 

may result in improper installation and decreased functionality.

Owner is responsible for proper use and avoidance of HAVEN as a trip hazard. 

Do not place HAVEN on unapproved surfaces to avoid additional trip hazards. 

Owner is responsible for ensuring the unit is clean for full functionality and capabilities.

CAUTION

USER MANUAL

   

2

Содержание HAVEN Connect Z



















Отзывы: