USER MANUAL
12
Supports 1 group (#1, Lifeline) with up to 5 nodes. Command classes reported to the Lifeline:
1. NOTIFICATION_REPORT
2. BATTERY_REPORT
3. DEVICE_RESET_LOCALLY
4. INDICATOR_REPORT
5. DOOR_LOCK_OPERATION_REPORT
Association Groups
Battery State and Charging
Battery state is checked upon startup and Battery CC V2 report is sent to the Lifeline Group.
Battery is then checked every 5 minutes. A battery report is also sent every 24 hours.
Indications and operation are as follows:
1. If battery falls below 25%, Battery report is sent to the Lifeline. One second later,
Notification CC sends Power Management (0x08) event “Charge battery soon” (0x0E).
Red LED flashes every 5 seconds.
2. If battery falls below 10%, Battery report is sent to the Lifeline. One second later,
Notification CC sends Power Management (0x08) event “Charge battery now” (0x0F). Red
LED flashes every 5 seconds and beeper chirps every 30 seconds. At this point, the gate
will no longer raise but can still be lowered.
3. When charger is plugged in, Battery report is sent to the Lifeline. One second later,
Notification CC sends Power Management (0x08) event “Battery is charging” (0x0C).
Yellow LED flashes every 2.5 seconds.
4. When charge is complete, Battery report is sent to the Lifeline. One second later,
Notification CC sends Power Management (0x08) event “Battery is fully charged” (0x0D).
LED return to flashing Magenta every (heartbeat interval) seconds.
Battery CC V2 support extended information in the Battery Report and can be queried at any
time with the Battery Get command. Additional information about the battery can be retrieved
with the Battery Health Get command.
