Havahart 5134G-B, Инструкция по эксплуатации

Страница: 17 / 41

Controller
Installing the Radial-Shape Wireless Dog Fence
Setting Up the Fence Boundary/Trigger Zone
15
Placing Training Flags:
Once your boundary is established, it’s time to place the Training Flags.
Training Flags are critical for the effective training of your dog and
should be placed every 6 feet at the fence boundary to enclose the
Roaming Area, where it will be safe for your pet to roam and play.
1.
Hold the Collar by the strap or grey battery container. Do not hold
the area where the strap meets the Collar on either side as this is
where the antennas are located (see the raised areas of the strap)
and your hand may interfere with the signal. Fully extend your arm
down by your side. Make sure that your body does not get between
the Collar and the Controller as your body may affect the signal and
cause the boundary to shift inward (see Factors Affecting Signal
Strength on page 32).
2.
Walk toward the boundary while gently moving the Collar until
the Collar beeps and the Collar light flashes red (see Figure 1.7). To
make sure that the distance is correct, step back 6 feet into the
Roaming Area until the Collar stops beeping and then walk
forward in the same direction until the Collar beeps and the
Collar light flashes red again. ( see Illustration E )
The fence boundary may not form a
perfect circle. Large metal objects such
as a car or refrigerator can slightly distort
the roundness of your fence boundary.
However, once set, the boundary location
will remain consistent over time.
(see Factors Affecting Signal Strength
on page 32. )
Havahart
®
Radial-Shape Wireless Dog Fence
www.havahartwireless.com
IMPORTANT MESSAGE
!
Fen
ce B
ou
nd
ary
/Tr
ig
ge
r Z
o
n
e
Illustration E
TIP : 6 feet is about 2 paces.