Haussmann HLG033, Руководство по эксплуатации

Страница: 22 / 39

gb
FUEL
Gas Trimmer Fuel Mixture
Never use straight gasoline in your unit.
This will cause permanent engine damage
and void the manufacture’s warranty for that
product. Use regular grade unleaded gasoline
mixed with 2-cycle engine oil in 40:1 ratio for
best results. Never use a fuel mixture that has
been stored for over 60 days.
GASOLINE - The lowest recommended
octane rating is 90. If you run the engine on
gasoline with a lower octane rating than 90
so-called “knocking” can occur. This leads to
an increased engine temperature which can
result in serious engine breakdown.
TWO-STROKE OIL - For the best results use
premium grade two-stroke oil mixed at a 40:1
ratio, intended for air cooled engines. Do not
use any 2-cycle oil product with a recom-
mended mixing ratio of 100:1. If needed,
contact your dealer when selecting oil.
OPErATINg INSTrUCTIONS
OPErATINg INSTrUCTIONS
WArNINg
!
UNPACKINg
If any parts are missing, do not operate this
tool until the missing parts are replaced. Fail-
ure to do so could result in serious personal
injury.
n
Carefully remove the product from the
carton.
n
Inspect the product to make sure no
breakage or damage occurred during
shipping.
n
Do not discard the packing material until
you have inspected and operated the
product.
The Haussmann HLG033 Gas Trimmer is
supplied with the following accessories:
n
Trimmer assembly
n
Front handle assembly
n
Grass guard assembly
n
String head
ASSEMbLy
Attaching the Front Handle (Fig. 1)
1. Remove the front handle, bolt, and
handle lock knob from box.
2. Attach the front handle onto the shaft
and snap into place. Locate the front
handle to a comfortable position.
3. Slide the bolt through the front handle.
NOTE: The hex bolt head fits inside the hex
recess molded into one side of the handle.
4. Attach and tighten the Handle lock knob.
WArNINg
!
Debris shield (Fig. 2)
The debris shield must be installed to properly
dispense trimming line and protect the
operator.
NOTE: Shield fits snuggly onto the shaft.
Some effort may be required.
1. Seat shield onto shaft bracket.
2. Insert bolt through hole. Bolt head should
fit into the hex shape in shield.
3. Insert washer and nut. Tighten securely.
Fig. 1
Handle lock knob
Front handle
Fig. 2
Debris shield
Shaft bracket