Haussmann Xpert 57265002, Руководство оператора

Страница: 23 / 31

23
ENGLISH
FUNCTIONAL DESCRIPTION
Your new air compressor can be used for operating paint, weed killer, and
insecticide sprayers, air equipments, grease & caulking guns, sandblasters,
inflation, etc. A tool with a higher air demand than this compressor can produce
may either not function, or not function well. It may also cause the compressor to
run without stopping for long periods of time, trying to maintain pressure in the tank.
This can cause either the motor or compressor pump to overheat and damage
them. Be sure the requirements of your tools can be met by the compressor.
To compress air, the piston in the pump moves up and down in the cylinder. On
the down stroke, air is drawn in through the inlet valve. Since the discharge valve
remains closed, as the piston goes up, the air in the cylinder is compressed. The
inlet valve closes and compressed air is forced out through the discharge valve,
through the check valve and into the air receiver. A check valve prevents it from
going back into the pump. Working air is not immediately available. Air becomes
available for use when the receiver pressure is above that required by the regulator
at the air service connection. The pump continues to add air until the air receiver
pressure builds to the factory preset cut-out pressure of the pressure switch. The
air inlet filter openings must be kept clear of obstructions or else it could reduce air
delivery.
A Rubber foot pads
B Rubber-tired wheel
C 28 gallon air tank
D Electrical power cord
E Safety pressure relief valve
F Tank pressure gauge
G Quick-connect air couplers
H Regulator knob
I
Regulated output pressure
gauge
J Compressor auto-on / off
switch
K Air filter / muffler
L
Oil fill plug
M Transport handle
N Oil level sight gauge
O Crankcase oil drain plug
P Moisture release petcock