Haussmann Xpert 57265002, Руководство оператора

Страница: 26 / 31

26
ENGLISH
!
!
OPERATION
BEFORE OPERATING
1. Check that all nuts and bolts are all snug.
2. Check the quantity and quality of oil (see compressor lubrication, above).
INITIAL BREAk-IN
1. Open (screw the knurled brass knob in, counter-clockwise) the moisture
release petcock (P, fig.1 & 6) on the bottom of the air tank to permit air to
escape, so that no air pressure builds up in the air tank.
2. Plug power supply cord into correct power source.
3. Pull up on the On/Off switch lever (J, fig.1) to start the compressor.
4. Run the compressor in this no-load condition for 15 to 20 minutes to lubricate
the bearings and pistons.
5. Close (turn the knurled knob out, clockwise) the air tank Moisture release
petcock.
6. Pressure will build in the tank and the pressure switch will stop the pump when
it reaches the pressure set on the regulator. Your compressor is now ready for
use.
NoTE:
During the break-in period, there may be a slight smell as the electrical
motor brushes seat themselves. This may last for about 5 minutes and is
normal.
CAuTIoN!
If the compressor does not run properly after 15 minutes of the
break-in or if you notice any abnormalities, please contact the service centre.
NoTE:
If the Pressure switch fails to shut off the compressor for any reason,
the compressor has a safety valve (pictured at E, fig.1 & 5) which will open
automaically when pressure in that tank becomes too great.
OPERATING INSTRUCTIONS
1. Be sure the On/Off switch (J, fig.1) is swung down & in the Off position.
2. Close (turn the knurled knob out, clockwise) the air tank moisture release
petcock (P, fig.1 & 6).
3. Plug in the power cord.
4. Pull up on the On/Off switch to turn the unit on.
5. Adjust the regulator (H, fig.1 & 5) so that the needle on the regulated output
pressure gauge (I, fig.1) is set to the working pressure of the air tool you plan
to use.
6. Connect the air tool to an air hose.
7. Connect the air hose to the compressor by inserting its quick-connector plug
into one of the two quick-connect air couplers (G, fig.1 & 5). Be sure the
connectors are properly connected.
8. Follow all instructions for the use of the air tool.
9. As air is used by the tool, the compressor will start up automatically to
replenish the pressure in the tank and stop when full. It will continue to cycle as
you work.
WARNING! The compressor motor and pump can get quite hot in operation.
Do not touch or allow others near the unit during or after operation.
10. When finished, disconnect the air hose by pushing the quick-connect plug in
slightly while sliding the sleeve on the coupler back to release the plug.
11. Swing down the On/Off switch to stop the compressor.
12. Open the moisture release petcock (P, fig.1 & 6) on the bottom of the air tank
and allow all the air to escape from the tank.