Haulotte HT132RTJ PRO, Книга по эксплуатации

Страница: 107 / 144

A
B
C
D
E
F
G
H
I
107
4000392130 E03.16 USA / GB
HT43RTJ PRO - HT132RTJ PRO
D
- Diagnosis assistance
Platform controls do not respond
Ground control box selector key is set to
ground control box position Turn the ground control box selector key to
platform control box position
Platform overload indicator
Remove some weight
Do not exceed the authorised limit
Section G 1-Main characteristics
'Enable Switch' control validation device is
not enabled Enable the device and keep pressed down
during movement
Faulty joystick
Replace the joystick
Contact HAULOTTE Services®
Faulty solenoid valve for the selected
movement
Replace the solenoid valve or the solenoid
valve coil
Contact HAULOTTE Services®
Not enough hydraulic oil Top up the oil level
Tilt or slope exceeding the authorised limit
Do not exceed the authorised limit
Section G 1-Main characteristics
Faulty fuse(s) FU6 Replace the fuse(s)
No power supply in the platform
Stow the machine using the ground control
box.
Check the connectors on the connecting
cable (top and bottom)
Machine not calibrated Contact HAULOTTE Services®
No high speed Platform extended Stow the machine completely
No telescoping Faulty joystick Replace the joystick
No boom lifting Faulty joystick Replace the joystick
No driving Failure following microspeed failure
Stow the machine
Switch off the power and then switch it back
on again
No steering
Not enough hydraulic oil Top up the oil level
'Enable Switch' control validation device is
not enabled Enable the device and keep pressed down
during movement
No horizontal drive, telescoping, lifting
or buzzer in operation
Tilt or slope exceeding the authorised limit
Do not exceed the authorised limit
Section G 1-Main characteristics
No turntable rotation
Turntable rotation locking pin is inserted in
the chassis
Remove the pin
Hydraulic pump is making an
abnormal noise
Not enough hydraulic oil Top up the oil level
Pump suction valves closed or not fully open Fully open the suction valves
A drive wheel does not hold the road Insufficient load on one wheel Press the differential locking selector
Buzzer in operation
Tilt or slope exceeding the authorised limit
Do not exceed the authorised limit
Section G 1-Main characteristics
Platform overload indicator
Remove some weight
Do not exceed the authorised limit
Section G 1-Main characteristics
Hydraulic oil temperature too high Allow to cool down
Axle not fully extended or retracted Fully extend or retract the axles
Outrigger cylinder is not fully retracted Fully retract the outrigger cylinder
Axle retraction/extension forbidden with axle
control box activated Stow the machine
Align the turret with the machine
Problem Probable cause Solution