Haulotte Group 3522A, Руководство по техническому обслуживанию оператора

Страница: 8 / 142

HAULOTTE GROUP 1 SAFETY
8
BEFORE OPERATION
Ensure the following general safety precautions are followed before operating the aerial work
platform:
ALWAYS
inspect the usage area for potential hazards, such as unstable or unlevel surfaces,
overhead obstructions and electrically charged wires or conductors.
ALWAYS
watch for moving
vehicles in the operating area.
ALWAYS
conduct a thorough visual inspection of the aerial work platform before operation. Check
for damaged or worn parts, hydraulic leaks, damaged wiring, loose wiring conductors, damaged
outriggers, low tire pressure, uneven tire wear or tire damage. Check for any improperly operating
components.
NEVER
operate the aerial work platform if any damage is observed or suspected.
Repair damaged or malfunctioning equipment before operation.
ALWAYS
wear proper clothing. Wear protective equipment as required by Federal, State and Local
codes and regulations. Keep loose clothing, jewelry, gloves and hair away from moving parts.
ALWAYS
wear a Safety Harness and energy-absorbing Lanyard, such as the Safety Harness and
Lanyard available through the Haulotte Group.
ALWAYS
inspect platform floor and outrigger footpads for mud, grease, debris or other foreign
material.
ALWAYS
remove any such material from the aerial work platform before operation.
ALWAYS
RED tag any part of this machine known or suspected to be damaged or malfunctioning.
ALWAYS
remove a malfunctioning, damaged or defective aerial work platform from service.
NEVER
operate an aerial work platform that has any known or suspected defect.
ALWAYS
comply with the instructions found in Safety and / or Service Bulletins distributed by the
manufacturer / factory. Bulletins may contain critical procedures that supersede the information
contained in this manual.
NEVER
operate this aerial work platform while under the influence of drugs or alcohol, while taking
prescription medications that may leave the operator drowsy or prone to dizziness, or while feeling ill.
NEVER
modify, alter or change the aerial work platform in any way that would affect its original
design or operation.
NEVER
deface, modify or obscure any decals or markings on the aerial work platform.
NEVER
operate this aerial work platform in any way for which it is not intended.
NEVER
operate this aerial work platform in explosive or flammable environments.
Before attempting aerial work platform operations, operator(s) should:

Attend a training program as required by all Federal, State, and Local codes and regulations.

Obtain, read and obey all safety precautions as indicated by manufacturer’s recommendations
and all Federal, State and Local codes and regulations.

Become familiar with the location and use of all controls.

Verify that there are no overhead obstructions or live power sources in the work area that could
interfere with the safe operation of the aerial work platform.

Cordon off the area surrounding the aerial work platform to keep personnel, vehicles and moving
equipment away from the aerial work platform while in use.

Position the aerial work platform on a firm and level surface.

Conduct a pre-operation inspection by performing all recommended daily service checks.
Refer to the “Equipment Maintenance” section of this manual.