8
To release the tool in "Manual" mode, the following conditions must be
fulfilled:
1.
The "Manual" mode must be set
2.
The unit is placed on a wall element (or similar) and the Work Piece
Contact (1) is activated
3.
Air supply is connected
4.
Press the safety button (2)
5.
The corresponding trigger (3) is actuated
6.
A drive-in process should happen
Manual release
Automatic release
1
3
2
To release the tool in the "automatic" mode, the following conditions must be
fulfilled:
1.
The "Auto" mode must be set
2.
The unit is placed on a wall element (or similar) and the Work Piece
Contact (1) is activated
3.
Air supply is connected
4.
Press the safety button (2)
5.
The corresponding trigger (3) is actuated
6.
Pushing / pulling the Inliner DC causes a drive-in procedure to be
triggered when pressing / reaching the set distance.
7.
If the maximum sliding speed is exceeded, misfires may occur.
