hattrick RB-4000 M, Руководство по эксплуатации

Страница: 23 / 24

23
32 EVA cushion 3 75 Bolt M5*12 6
33
Left upright tube
cover 1 76 Bolt M8*35 2
34
Right upright tube
cover 1 77 Bolt M8*25 6
35 Bolt M6 8 78 Massage head 1
36 Bolt M8 8 79 Massage belt 1
37 Bolt M8 2 80 Connecting frame 1
38 Bolt M8*35 1 81 Supporting frame 1
39 Bolt M8*15 13 82 Foam 4
40 Bolt M8*20 4 83 End cap 4
41 Bolt M8*30 1 84 ARC washer 4
42 Bolt M8*40 2 85 Bolt 6
43 Bolt M8*40 4
TROUBLE SHOOTING
1
、
Probable reason for computer not workable after power start: The wire from computer to
bottom control board didn’t connected well or the transformer was burnt out. Check the each wire
from computer to control board, make sure they are connected well. If the wire is destroyed ,
change it. If the above can not settle the problem, try to change a good transformer.
2
、
E01: Message failure. Probable reason: The wires from computer and bottom control board did
not connect well, please check each wire. If the wire was destroyed, change a good one.
3
、
E02: Burst clash. Check the power is right, if not, use correct power to test; Check if the bottom
control was burnt out, change a good one; reconnect the motor wire.
4
、
E03: No sensor signal. Check if all sensor wire are good, if damaged, change a good one. If not
works, check if the speed sensor is ok, if damaged, change the speed sensor. If still not works,
check if the motor wire connect well or need to chagne motor.
5
、
E05: Current overload protecting. Over rated loaded or the motor is stuck, cause excessive
current, machine will start self-protecting system. Adjust the machine and restart; Check if the
motor has noise from motor or if the motor / bottom control board were burnt out, if burnt out,
change good motor and bottom control; Use right voltage.
6
、
If the motor can not work after pressing START button, the probable reason: the motor wire is
broken; the safety pipe is broken or fell; motor wire is not conneted well; IGBT on bottom control
board is burnt out. Test the above reasons and change the relevant part.