Hatteland HD 12T21 STD-xxx-Fxxx, Руководство пользователя

Страница: 28 / 90

28 Installation
IND100078-34
Installation Procedures
Mounting Bracket, Table / Desktop / Ceiling - 12”,15”,17”,19”
Procedure suitable for: Display (MMD/STD) and Panel Computer (MMC) Series X product ranges.
You need:
- M4, M5, M10 Unbrako® Hex Key tool, M10 Wrench (not included with delivery).
- Fasteners (6 pcs M6) for mounting complete unit onto table or desktop location (not included with delivery).
- 1 pcs of HD xxBRD SX1-A1 Mounting Bracket Kit, where xx=12, 15, 17 or 19 inch (shipped during 2012 > 2013)*
- or 1 pcs of HD TMB SX1-A1 (12” / 15”) or HD TMB SX1-B1 (17” / 19”) Mounting Bracket Kit (shipped during 2013 >)*
Bracket Arms are clearly marked with Typenumber label so you can identify which version you have (BRD or TMB).
Ceiling mount of complete unit is only supported for “Double Key Hole” units, see next page for infomation.
Attention: A suitable pre-drilled location and knowledge of measurements for both main unit and
brackets/tilting functionality should be prepared and checked prior to mounting. Please disconnect
ALL cables before proceeding. Please review User Manual or visit www.hatteland-display.com for
Technical Drawings regarding measurements for both main unit and Mounting Brackets.
▼ 1: Place the unit on a dry, flat, clean, soft surface (i.e.
table) with the glass front facing down as illustrated.
Connector area should be facing downwards from you.
▼ 2: Inspect the inner side of both brackets and especially the
orientation of the Key Hole Plug (4 pcs). They should be shaped
as an standing “egg” to ensure proper fitting in the Key Hole of
unit (FIG1). Note: You may have to loose the fastening screw (M5)
(FIG2) if the Key Hole Plug can not be turned by hand.
Seen from
above
Connector Area
Wrong Correct
Adjust
FIG2
FIG1
▼ 3: Verify that the Key Hole Set Screw (M4) is aligned
with the bracket surface (FIG1). If this screw appear too
far out (FIG2), proper fitting into the Key Hole can not be
completed. Turn screw clockwise or anti-clockwise (FIG3)
to adjust the position. (BRD version only, not present on
TMB version).
▼ 4: Notice the indication of LEFT and RIGHT. The mounting
bracket (2 pcs) is marked with respective stickers “L” and “R” from
factory. Please make sure that LEFT bracket is positioned on LEFT
side and RIGHT bracket is positioned on the RIGHT side as shown
below.
Wrong Correct Adjust
FIG1 FIG3 FIG2
Bracket Surface
LEFT RIGHT