Hatteland HD 12T21 MMC Series, Руководство пользователя

Страница: 33 / 112

33 Installation
IND100078-33
Installation Procedures
Mounting Bracket for Table / Desktop installation - 24”, 26” and 27”
You need: M5 Unbrako® Hex Key tool and 1 pcs of HD TMB SX1-C1 Mounting Bracket Kit. Fasteners (6 pcs M6) for
Table / Desktop location not included. Procedure suitable for: Display and Panel Computers. 24 inch unit used as
illustration below, but same procedure apply for 26 and 27 inch units as well.
Attention: A suitable pre-drilled location should be prepared and checked prior to mounting.
Please disconnect ALL cables before proceeding. Please review User Manual or visit
www.hatteland-display.com for Technical Drawings regarding measurements for both main unit and
Mounting Brackets.
▼ 1: Place the unit on a dry, flat, clean, soft surface
(i.e. table) with the glass front facing down as
illustrated. Connector area should be facing
downwards from you.
▼ 2: Inspect the mounting holes of brackets. For mounting
to a 24 inch unit, please use the lower holes as indicated.
For mounting to a 26 / 27 inch unit, please use the upper
holes as indicated.
Seen from
above
Connector Area
24 inch
26 inch
27 inch
▼ 3: Place one bracket at the time with the mounting
holes facing down into the suitable mounting
position and fasten with 2 x M5 screws on each
bracket. Torque Force 3.5Nm.
▼ 4: While unit is lying flat on table, check the Tilting Lock
Pin position. These can be pulled out by hand, turned 90°
(FIG1) and turned back 90° until the Lock Pin automatically
clicks into place by a spring (FIG2).
FIG1
FIG2
FIG2
FIG1
FIG2
Locked Unlocked
Released